Wiring Notes
From Ug11bm
Jump to navigationJump to searchWiring Notes
PinDiagram_MaileView_10pin_Winchester.png
Sample Stick A: Auxiliary
Pins A,B,C,D = Phytron Stepper Motor Motor Phase = Motor Wire = 10 Pin = Connector Wire = Elco 1+ red A white A 2+ blue B black C 1- yellow C red E 2- green D brown H not used E not used F Pins H, J, K, L = Diode Temp Sensor Diode = Diode Wire = 10 Pin = Connector Wire V+ red H green V- white J white I+ red/black K red I- white/black L black
Sample Stick B: Auxiliary
none
LakeShore Diode - ITC Sensor 3
Diode = Diode Wire = DB9 Pin = ITC = Connector Wire V+ red 2 Input Low green V- white 1 Input High white I+ red/black 4 Current +ve red I- white/black 5 current -ve black
Sensor 1 Notes
Heaters (x2) + RhFe Resistor
Wiring Pin Function A --> Heater + (x2, running in parallel) B --> Heater - C --> V+ Resistor D --> V- Resistor E --> I+ Resistor F --> I- Resistor H --> ? J --> spare K --> ? L --> ?
Pin Resistance - NEW Cryostat Pins Expected (Ohm) Measured (April 2011) A-B --> 15-25* 36 C-D --> 30-40 34.5 C-E --> < 15 5.2 C-F --> 30-40 34.6 E-F --> 30-40 34.6 A-C --> > 1 M open A-GND --> > 1 M open C-GRN --> > 1 M open * according to Oxford, each heater is 68 Ohm. Running parallel (1/R1+1/R2 = 1/Rtotal) gives Rtotal expected = 34 Ohms
Pin Resistance - OLD Cryostat Pins Expected (Ohm) Measured (April 2011) A-B --> 15-25 36.5 C-D --> 30-40 35.5 C-E --> < 15 6.0 C-F --> 30-40 35.5 E-F --> 30-40 35.5 A-C --> > 1 M open A-GND --> > 1 M open C-GRN --> > 1 M open