TEXIO PD18-30AD DC Power Supply
From Ug11bm
Jump to navigationJump to searchThe printable version is no longer supported and may have rendering errors. Please update your browser bookmarks and please use the default browser print function instead.
Notes below are for the TEXIO PD18-30AD DC Power Supply. It is primarily used at 11-BM to provide power for resistive heating coils in the flow cell sample environment.
Manuals
TEXIO_PD18-30AD_DCPowerSupply_Manual
Specs
- 0 - 30 Amps
- 0 - 18 V
- 0 - 450 Watt
Operation & Settings
Front Panel
- Turn On PD18 Power
- Adjust Voltage/Current Settings/Limits if needed (see below)
- For 11-BM resistive heating coils, connect matching Blue-White & Red-Red lead wires (as shown below)
- For 11-BM resistive heating coils, isolate ground connection (as shown below)
- ENABLE OUTPUT press OUTPUT button, enabled = red light ON
- CC (red) and/or CV (green) lights indicate output is limited by Current Limit state (CC) or Voltage Limit state (CV)
Image of Front panel of TEXIO PD18-10AD DC Power Supply
Back Panel
Image of Back panel of TEXIO PD18-10AD DC Power Supply
- #1 - 12 are input terminals for remote control and series/parallel operation.
- For control by external voltage (i.e. SRS temperature control), connect voltage across pins 4 - 5 (as shown below)
- External voltage should be 0-10 V, with impedance ~ 10 k Ohms
Voltage / Current Settings
- Manually set by turning big Current & Voltage Knobs
- When controlling remotely, these values will set the V & I limits
- To check setting, press V/I CHECK, then check value and adjust if required.
