Mail-In Powder Diffraction Measurements

From Ug11bm
Jump to navigationJump to search

See older Mail-In Sample Prep Notes @ 11-BM Webpage or as .pdf download

Safety and Training

Review sample hazard restrictions for mail-in experiments.

Be aware of APS safety and training guidelines www.aps.anl.gov/Safety_and_Training/

Many APS rules apply only to on-site users, but mail-In users should review notes for Experiment Hazard Classes and restrictions on the shipping of samples.

Kapton Tubes for Mail-In Measurements

The supplied Kapton capillary tubes for 11-BM mail-in experiments have an inner diameter of 0.80 mm, and an outer diameter that fits snugly inside 11-BM mounting bases.

See more details on Kapton capillary tubes

Note: All sample powders must be fully contained and secured within these capillary tubes.

Nesting Capillaries inside Kapton Tubes

Some mail-in samples may require additional glass or fused quartz capillary tubes nested inside the standard Kapton tube.

Any additional capillary must fit and be secured entirely inside the supplied Kapton tube.

If returning samples loaded in glass capillaries, please leave a note in the package so we be sure to take extra care when handling.

See the Wiki for Instructions on Nesting Capillaries.

This can be useful for samples which are:

Note: 11-BM does not provide glass or quartz capillaries for mail-in experiments. Only Kapton tubes (with an inner diameter of 0.81 mm) are provided for the mail-in service. See the Wiki for more info (vendors etc) on glass or fused quartz capillaries.

Beam Size and Position

Properly prepared sample for the 11-BM mail-in service

Sample view through the "upstream" camera. sample view through the video microscope.

Two views of a sample in position for data-taking, as seen through the "upstream" camera (left) and the video microscope (right). The reticle lines show the nominal extent of the beam. The actual beam edges extend somewhat farther, so these areas should be kept clear of foreign material (glue, clay, wax, etc.). The sample material must be held in place in the beam -- if it is loose in the capillary, it will move when we spin the capillary (we spin at about 5400 r.p.m.). In addition, there must be no lumps of material at the end of the capillary, since this could cause the capillary to bend or break during spinning, and such a lump may also cause a robot malfunction when it attempts to load or unload the sample.

Tools

User may find some of the following tools helpful when preparing samples:

  • Small Drill Bits can be useful for loading & packing powder inside Kapton tubes (more details)
  • Powder Sieves help remove any large particles and ensure homogeneous powders (more details)
  • Mortar & Pestles Agate mortars and pestles are invaluable tools for grinding powder samples (more details)