View source for TEXIO PD18-30AD DC Power Supply

Notes below are for the TEXIO PD18-30AD DC Power Supply. It is primarily used at 11-BM to provide power for resistive heating coils in the flow cell sample environment.

== Manuals ==

[http://s11bmsrv1.xor.aps.anl.gov/staffdocuments/TEXIO_PD18-30AD_DCPowerSupply_Manual.pdf TEXIO_PD18-30AD_DCPowerSupply_Manual]

== Specs ==
*0 - 30 Amps
*0 - 18 V
*0 - 450 Watt 

== Operation & Settings ==
=== Front Panel ===
*Turn On PD18 Power 
*Adjust Voltage/Current Settings/Limits if needed (see below)
*For 11-BM resistive heating coils, connect matching Blue-White & Red-Red lead wires (as shown below)
*For 11-BM resistive heating coils, isolate ground connection (as shown below)
*'''ENABLE OUTPUT ''' press OUTPUT button, enabled = red light ON
*CC (red) and/or CV (green) lights indicate output is limited by Current Limit state (CC) or Voltage Limit state (CV)

Image of Front panel of TEXIO PD18-10AD DC Power Supply

[[Image:PD18-10AD_front.png|frameless|500px|Front panel of TEXIO PD18-10AD DC Power Supply]]


=== Back Panel ===
Image of Back panel of TEXIO PD18-10AD DC Power Supply
* #1 - 12 are input terminals for remote control and series/parallel operation.
* For control by external voltage (i.e. SRS temperature control), connect voltage across pins 4 - 5 (as shown below)
* External voltage should be 0-10 V, with impedance ~ 10 k Ohms

[[Image:PD18-10AD_back.png|frameless|300px|Back panel of TEXIO PD18-10AD DC Power Supply]]



=== Voltage / Current Settings ===

* Manually set by turning big Current & Voltage Knobs
* When controlling remotely, these values will set the V & I limits
* To check setting, press V/I CHECK, then check value and adjust if required.