Difference between revisions of "34-ID-C"
From 34-ID-C
Jump to navigationJump to search| Line 10: | Line 10: | ||
[[File:Heater1.jpg|320px]] [[File:Heater2.jpg|320px]] | [[File:Heater1.jpg|320px]] [[File:Heater2.jpg|320px]] | ||
'''Linkam Cryo stage''' | |||
The guts of this cell is a Linkam THMS controller. Temperatures as low as -100 C are possible but since the 3D printed chamber is not vacuum compatible, icing can be significant. Development of a highly dried gas environments is underway to minimize icing. The cell can also support moderate heating, limited by the melting of the 3D printed chamber. We've maintained 50 C for many hours with no problem. | |||
== Available Detectors == | == Available Detectors == | ||
Revision as of 17:32, 24 February 2018
Setup Images and Drawings
Media: 34IDC_basic_instrument_diagrams_for_mounting_assistance_etc.pdf
Sample Environments (Resident at beamline)
Heater Cell
The heater cell is capable of several hundred degrees centigrade. Improvements are underway to reach up to 1000 C. It also supports a single gas flow through the chamber. It is not vacuum compatible.
Linkam Cryo stage
The guts of this cell is a Linkam THMS controller. Temperatures as low as -100 C are possible but since the 3D printed chamber is not vacuum compatible, icing can be significant. Development of a highly dried gas environments is underway to minimize icing. The cell can also support moderate heating, limited by the melting of the 3D printed chamber. We've maintained 50 C for many hours with no problem.
Available Detectors
add stuff here
